FlyDroneMap

Drone GSD Calculator

From your altitude and camera specs, find how much ground one pixel covers (GSD), the footprint of each photo and the shot spacing for your overlap.

Drone GSD Calculator
Photo by Christopher Burns on Unsplash

Height above ground level (AGL).

Camera

The lens's real focal length, not the 35 mm equivalent. Use the "actual" value from the spec sheet.

Overlap and speed

Enter it to also get the shot interval in seconds.

Results

GSD2.34 cm/pixel
Altitude100 m
Footprint width (one photo)128.2 m
Footprint length (one photo)85.4 m
Distance between shots17.1 m
Flight line spacing38.4 m

Assumes the image's short side points along the flight direction. If you shoot with the camera rotated 90 degrees, swap width and height.

Results are based on your inputs and general assumptions, for reference only. Before a flight or trip, check the manufacturer's manual, your airline's guidance and local regulations.

How to use

  1. Choose "Altitude → GSD" and enter your altitude, or choose "Target GSD → altitude" and enter the resolution you want.
  2. Tap a sensor format or type the sensor size, then enter the lens's actual focal length and the image size in pixels.
  3. Set forward and side overlap to get the distance between shots and the flight line spacing. Add a speed to get the shot interval in seconds.
  4. Check that the resulting altitude is within your local maximum flight height, and adjust the target or camera if needed.

How it is calculated

GSD (cm/pixel) = altitude (m) × sensor width (mm) ÷ (focal length (mm) × image width in pixels) × 100. For example a 1-inch sensor (13.2 mm), 10.3 mm lens and 5472 pixels flown at 100 m gives about 2.3 cm/pixel.

The footprint is GSD times the pixel count. Distance between shots is footprint length × (1 − forward overlap) and line spacing is footprint width × (1 − side overlap). Sensor sizes are typical values per format and can differ slightly from the manufacturer's spec.

Frequently asked questions

Is a smaller GSD always better?

A smaller GSD means each pixel covers less ground, so you see more detail. But covering the same area needs a lower altitude and more photos, which costs flight time and battery. Choose only as fine as your purpose needs.

Which focal length should I enter?

Enter the lens's actual focal length (for example 10.3 mm), not the 35 mm equivalent. If you only know the equivalent, divide it by the crop factor to get the actual value.

How much overlap is enough?

For mapping, about 70–80% forward and 60–70% side overlap is common. Low-texture ground such as forest or water usually calls for more.

Does this guarantee survey accuracy?

No. It is a theoretical figure for photo resolution. Real survey accuracy depends on ground control, position correction, lens distortion correction and terrain relief.

Check weather and Kp before you fly

Once you have your numbers, check wind, temperature and the Kp index for your flight area on the dashboard.

Open the dashboard

Guides worth reading next

More tools